Is the ELEGOO Centauri Carbon 2 or Bambu Lab P1S Better for Multicolor Printing?

The CC2 wins on included value: its CANVAS module ships four spindles and RFID auto-detection in the box for $449. The P1S Combo bundles a full AMS unit for $549, with room to add more AMS units later for up to 16 colors.

Both use a CoreXY frame rated for 500 mm/s and 20,000 mm/s² acceleration on paper. Neither reviewer set reported hitting those numbers on real prints — cooling and part geometry cap real-world speed on both machines.

How Does CANVAS Compare to AMS in Practice?

A verified CC2 buyer described CANVAS as effortless once the spindles are numbered correctly during assembly — spindle 1 feeds position 1, and so on. The same buyer called the RFID auto-detection “pretty dang cool” since it reads ELEGOO’s own reels and sets color/type automatically.

P1S buyers were split on setup ease. One reviewer called it “top notch” with flawless device connections; another reported the WiFi/Bluetooth “binding” process took about an hour to work through, separate from actually printing.

Which Printer Handles High-Temperature Filaments Better?

The CC2’s listed nozzle ceiling is 350°C with a titanium-alloy heat break and brass-hardened steel nozzle — enough headroom for most engineering filaments sold to hobbyists. Amazon’s listing for the P1S Combo doesn’t publish a matching nozzle-temperature figure, so we’re not going to guess at one here.

What we can compare directly: the P1S lists carbon and glass-fiber-reinforced filament as “not recommended,” while the CC2’s listing claims capability with fiber mixes. If you’re printing reinforced nylon or similar, that’s worth confirming against Bambu’s own spec sheet before you buy.

Is the ELEGOO Centauri Carbon 2 Combo an Enclosed Printer?

No. The CC2 is an open-frame CoreXY design, based on its listing and the reviewer’s assembly walkthrough — there’s no mention of an enclosure anywhere in the product data. The Bambu P1S Combo is explicitly listed as “Fully Enclosed Design.”

An enclosure matters most for ABS and ASA, which warp and crack more in open air. If you print a lot of ABS parts, that’s a real point in the P1S’s favor.

The Reality of Long-Term Ownership

Maintenance & Wear

A verified CC2 owner reported that build-plate calibration only needs to run about once a month, and adhesion held up across every early print, including a benchy torture test. On the P1S side, one buyer specifically warned not to peel the protective padding off the build plate until after the first calibration cycle — doing it too early caused problems for them.

One P1S buyer’s unit arrived with a hot end that wouldn’t feed or retract filament and had to be returned — worth knowing before you assume every unit prints flawlessly out of the box, even though most reviewers reported no such issue.

Hidden Costs

ELEGOO doesn’t publish CC2 firmware files for self-service reinstalling — if your firmware gets corrupted, you’re contacting support directly for a link, which costs you time, not money. One P1S buyer mentioned third-party replacement screens exist for the printer’s stock display, which they considered upgrading because they found the factory screen dated and hard to navigate.

ELEGOO Centauri Carbon 2 vs Bambu Lab P1S: 8 Key Differences

ELEGOO Centauri Carbon 2 Combo: Full Look

At $449, this is the printer to buy if your main goal is 4-color prints without adding hardware later. It also runs the higher published nozzle ceiling of the two, which matters if you print engineering filaments.

Bambu Lab P1S Combo: Full Look

At $549, the P1S Combo costs more but carries the stronger buyer track record of the two — 4.3/5 across 597 ratings versus the CC2’s 3.8/5 across 252. It’s also the only one of the two that’s fully enclosed.

Pros and Cons

Frequently Asked Questions

Related Reading